HEIDENHAIN TNC 407 (243 020) Technical Manual Benutzerhandbuch
Seite 751
13-10
TNC 407/TNC 415/TNC 425
Stichwortverzeichnis
11.97
Q
Q-Parameter ......... 2-4; 4-140; 4-154; 7-21; 9-4
R
R (RESET) ...............................................7-49
Radialbeschleunigung ...............................4-80
Rampensteilheit......................................4-114
Rampensteilheit für Spindel .....................4-97
Rechenzeit ..................................................7-7
Rechte-Hand-Regel...................................4-12
Reduzierter Vorschub der Werkzeugachse
................................................................4-161
Referenz-Endlage .....................................4-53
Referenzimpulssperre ..............................3-36
Referenzmarke ............4-36; 4-52; 4-62; 4-109
Referenzmarken .........................................4-7
Referenzpunkt ..........................................4-16
Regelfeinheit.............................................4-71
Regelkreis öffnen .....................................4-92
Regelung mit Schleppabstand..................4-66
REPEAT ... UNTIL -Struktur ....................7-128
REPLY.....................................................7-123
RESTORE ........................................2-15; 2-22
Restore at N ...........................................4-148
Restore Position ..........................4-148; 4-149
RM = Referenzmarke .............................4-127
RN (RESET NOT) ....................................7-51
ROT ..........................................................2-19
RPLY (REPLY) .......................................7-124
RS-232-C...................................................8-10
RS-422 ......................................................8-15
RT ...........................................................4-227
Rückmeldung M-Funktion ......................4-159
Rückmeldung S-Code .............................4-104
RÜCKSETZE (R) ......................................7-49
RÜCKSETZE NICHT (RN)........................7-51
Rundung eingefügt ...................................4-82